GB0-180 Huawei Certified Network Engineer Testking Exam

Huawei ™

GB0-180 Huawei Certified Network Engineer

Note 1: GB0-180 Exhibit and all related diagrams are not shown in demo questions.
Note 2: GB0-180 Answers are not shown in demo questions.
Exhibits and Answers are only provided in the Full Version.

Demo Question 6.

Exhibit As shown in the following networking figure. Assume the default gateway configuration of each host is correct. The specific configuration is as follows: Now create configuration... Current configuration ! version 1.74 firewall enable sysname EliteCertify A encrypt-card fast-switch ! interface Aux0 async mode flow phy-mru 0 link-protocol ppp ! interface Ethernet0 ip address 10.0.0.1 255.255.255.0 ! interface Serial0 clock DTECLK1 link-protocol ppp ip address 10.0.1.1 255.255.255.0 ! interface Serial1 link-protocol ppp ! quit rip network all ! quit ! return Now create configuration... Current configuration ! version 1.74 firewall enable sysname EliteCertify B ! acl 101 match-orderauto rule normal permit ip source 10.0.2.2 0.0.0.0 destination 10.0.0.2 0.0.0.0 rule normal deny ip source any destination any ! interface Aux0 async mode flow phy-mru 0 link-protocol ppp ! interface Ethernet0 ip address 10.0.2.1 255.255.255.0 ! interface Serial0 link-protocol ppp ip address 10.0.1.2 255.255.255.0 firewall packet-filter 101 outbound ! interface Serial1 link-protocol ppp ! quit rip network all ! quit ! return Is the conclusion that PC EliteCertify 1 can ping PC EliteCertify 2 successfully true?

A. True
B. False

Display Answer

Purchase Full Version:

GB0-180 Printable PDF Prep Guide $49.95 BUY NOW!

GB0-180 Test Simulation Engine $69.95 BUY NOW!

GB0-180 PDF & Test Simulation Engine $99.95 BUY NOW!

Answer: B

Explanation: