642-812 Building Converged Cisco Multilayer Switched Networks Practice Exam

Cisco ™

642-812 Building Converged Cisco Multilayer Switched Networks

Note 1: 642-812 Exhibit and all related diagrams are not shown in demo questions.
Note 2: 642-812 Answers are not shown in demo questions.
Exhibits and Answers are only provided in the Full Version.

Demo Question 1.

Network topology exhibit: Configuration exhibit: Study the exhibits above carefully. VLAN2, VLAN3, and VLAN10 are configured on the switch EliteCertify V. Host computers are on VLAN 2 (10.1.2.0), servers are on VLAN 3 (10.1.3.0), and the management VLAN is on VLAN10 (10.1.10.0). Hosts are able to ping each other but are unable to reach the servers. Based on the information above, which configuration solution could rectify the problem?

A. Assign an IP address of 10.1.3.1/24 to VLAN3.
B. Configure default gateways to IP address 10.1.2.1 on each host.
C. Enable IP routing on the switch EliteCertify V.
D. Configure a default route that points toward network 200.1.1.0/24.
E. Configure default gateways to IP address 200.1.1.2 on each host.
F. Configure default gateways to IP address 10.1.10.1 on each host.
G. None of the above

Display Answer

Purchase Full Version:

642-812 Printable PDF Prep Guide $49.95 BUY NOW!

642-812 Test Simulation Engine $69.95 BUY NOW!

642-812 PDF & Test Simulation Engine $99.95 BUY NOW!

Answer: A

Explanation: Although a routed port is configured for connectivity with an external router, Inter-VLAN routing would most likely be achieved through the use of a virtual interface. Example: To route between VLANs 10 and 20 which have been configured on the multilayer switch use the following configuration: RouteSwitch(config)#interface vlan 10 RouteSwitch(config-if)#ip address 10.0.10.1 255.255.255.0 RouteSwitch(config)#interface vlan 20 RouteSwitch(config-if)#ip address 10.0.20.1 255.255.255.0